EcoPlasma 900  
   
   
EcoPlasma
EcoPlasma
EcoPlasma        
EcoPlasma
     
         
EcoPlasma

Plasma International AS1300 - The Sun on Earth

  

AS1300 Application:

  • Solar & Materials Research
  • Environmental Studies
  • Horticultural Studies
  • Population and Climatological Studies
  • Indoor Livestock Studies
  • Aquatic, Avarian & Vivarium Studies
Full, Continuous & Highly Efficient
Spectrum
Lamp Power Rating 1000W
Envelope Sphere
Outer Diameter		 AS: 32mm
AAA: 35mm
Lamp Rotation 0 to 6000rpm
EcoPlasma
Plasma Lamp and Plasma Drive Synergy
System Power Rating
1360W (AvFP 5.9A 230VAC)
System Efficiency
<140Lm/W
Plasma-i Lamp Life
>99,000Hrs
Light Engine Magnetron
>40,000Hrs
Weight
<12Kg
Light Engine Size
L250 x W190 x H175 mm
PSU Size
L250 x W150 x H195 mm
EcoPlasma
Electrical Performance
Input data
Mains voltage
230 VAC +-10%
Mains frequency
45-65 Hz
Power factor
>0.95 at 1300W and 230 VAC
Output data
Anode power
100-1300 W set in 10W steps. Regulated by CPU.
Anode voltage
(Application dependant)
Anode current
25-350 mA
(Application dependant)
Filament current
4-10 A. (Parameter setting varied by application.)
Efficiency
>93% at full power
Protection
  
Filament circuit
Open circuit / short circuit protected
Anode circuit
Open circuit / short circuit protected.
Software/Interface
  
Interface
RS 232 optically isolated.
Control
Microsoft Windows compatible
multi-lamp remote control
networking module available
EcoPlasma
Approvals & Environment
Safety
EN 61010
Harmonics conducted
EN 61000-3z
EMC & CE
EN 61000-6- 3 Emission (Industry),
EN 61000-6-2
Immunity
Ambient Limits
-25 to +50 C°
Humidity
(Non Condensing)
EcoPlasma
Narrow Spectrum
Typical spectra
  
Center fq
2,45 GHz
Fq scale
2 MHz/div
RBW
30 kHz
Amplitude scale
10 dB/div
 
narrow spectrum
 
 
EcoPlasma
EcoPlasma
EcoPlasma
Plasma International
Standard Sulphur Lamp
SS - Standard Sulphur
EcoPlasma
Plasma International
AAA Class Lamp
AAA Class
EcoPlasma

Plasma-i AS1300 Light Engine

The Plasma-i Light Engine generates a solar like light flux. The lamp power can be set by software to a desired level between 500W and 1300W and the light spectrum remains almost unchanged between 600W and 1300W power setting.

This unique spectral property is achieved with our electrodeless bulb design, where the bulb converts the externally generated HF energy into light at high efficiency.

The HF energy (microwaves) are generated with a magnetron that is powered from an adjustable stabilized power source.

Both the light engine & power supply are air cooled with fans.

Characteristical variances in bulb mix range: The CRI is between 98 (60 lm/W) & 80 (140 lm/W) and hot re-strike is between 20 & 180 seconds depending on which bulb mix is used.

Operating Conditions: Ambient temperature +5°C to +35°C Humidity <60%, non-condensing. As no filter is provided on the air cooling system the standard system has to operate in a clean environment with no dust emitting processes nearby.
EcoPlasma
System Specifications (with Standard Sulphur Bulb):
Designation: Plasma-I Model: AS1300 version 1.1
System power: 1360W 5.9A 230 VAC Luminous Flux: >163,000 lm
Input electrical power at 230VAC: 500
to 1,300 W		 Output optical power for 1m2: 380 to 1,010 W
Power Factor: >0.95 Emissions Standard: Fully EC compliant (2010)
Discharge bulb: Electrodeless, Sulphur based (SSX) Spectral shift: None
Luminous effi ciency: 140lm/W Correlated Colour Temperature: 6,000K
Colour Rendering Index: 80 Lamp intensity shift: None
UV output: <380nm 0.14% IR output: >780nm 8.0%
Convected & Conducted Heat: <19% Total Heat: <27%
Design Lifetime: ca. 99,000Hr Service: Magnetron change every 40,000Hr
Cooling of system: Fans (3x) 36dB Cooling: 140m3/hr exhaust 25°C higher than intake
Light Engine Size: L250 x W190 x H175 mm Mass of Light Engine: Approx. 9Kg
PSU Size: L250 x W150 x H195 mm Mass of PSU: Approx. 3Kg
PSU Control Facility1: Hardware manual control ON/OFF with variable input power control (dimming). PSU Control Facility 2: Hardware voltage control. BMS compatible 0 to 10V control. 3.5mm jack plug.
PSU Control 3: Networking Hardware & Software requires a single PC with Windows XP/ W7 & RS232 port. Can be used to control several light engines. PSU Control 4: Software including power and temperature monitoring information requires a single PC with Windows XP/ W7 & RS232 port.
EcoPlasma
EcoPlasma
EcoPlasma EcoPlasma
EcoPlasma